The PocketWizard N-MCDC2-ACC is a Pre-Trigger Remote Cable for Nikon Cameras like the D90, D5000, D7000 and more. Check the specifications for more details

Supports Half-Press and Full Press Function

A pre-trigger cable allows you to control both the half-press and full-press function of your camera. In pre-trigger mode, just like when your shutter button is half-pressed it allows you to activate autofocus or metering on your camera.

Includes a MSMM Adapter

The cable includes an MSMM or stereo to mono miniphone adapter that converts a MCDC2-ACC cable to a standard N-MCDC2 miniphone cable. This ensures wide compatibility with PocketWizard Radio Units for basic remote triggering but does not support half-press control.

PocketWizard Compatibility

The N-MCDC2-ACC Pre-Trigger Remote Cable for Nikon is compatible with a wide range of PocketWizard systems like the PlusX, Plus III, FlexTT5, as well as the MultiMAX with ACC port to a Nikon 10-pin remote shutter release terminal. You can also use system like the Plus II, older MultiMAX or other PocketWizard radios using a N-MCDC2-P or N-MCDC2 cable.

Cable length

91.5 cm or 30cm


1/8" (3.5 mm) stereo miniphone


Nikon MC-DC2 remote shutter release terminal

PocketWizard Compatibility

PlusX (Use this cable with the PlusX to trigger the camera)


Plus III (Use this cable with the Plus III’s exclusive 2-stage trigger to wake-up or focus your remote camera just like using the camera’s shutter release button)


FlexTT5 (This cable is required for auto-relay mode with E-TTL, or other remote triggering with the FlexTT5. Learn more here. You can use a N-MCDC2–P (-P) Pre-Trigger cable or N-MCDC2 Standard Cable with a FlexTT5, but your remote camera will not be able to relay an E-TTL signal to Speedlites. The FlexTT5 does not support the 2-stage trigger function)


MultiMAX (Enable a remote zone with your hand-held MultiMAX, and your remote MultiMAX will wake up its remote camera with this cable. As long as the zone is turned on, the remote camera will stay awake and respond more quickly and consistently, but also consume the camera's batteries much more quickly. When the remote zone is disabled, the camera will enter its normal sleep modes. The MultiMAX does not support the 2-stage trigger function)


Use the N-MCDC2-P or N-MCDC2 for the Plus II, older MultiMAX, or other PocketWizard radios.

Camera Compatibility

Supported Nikon Cameras : D7100 , D7000, D5300, D5200, D5100, D3300, D3200, D3100, D750, D610, D600, D90, Df, Z6, Z7


Unsupported Nikon Cameras : D70s, D80 (Use NM4-ACC instead)

* Specifications subject to change by the manufacturer without notice

PocketWizard Pre-Trigger Remote Cable for Nikon - N-MCDC2-ACC


* Dispatch timeframes are indications only and may vary for multiple quantities. Timeframes are updated regularly during normal business hours.